|
10-17-2004, 10:33 AM
|
#1 |
|
PIMPING RIDES
Join Date: Sep 2004
Location: SPRING,TEXAS
Posts: 296
|
a frame
the bottom a frame on my truck doesn't look like it is positioned right . ok you knowhere the u joints hold it to the crossmember does the a frame fit centered are pushed back even with the frame . if i could see some pictures of a finished front end i will know where to put it . i took pic of before i started took them to walmart and they f**ked them up the compensated me but i lost the pix .
__________________
1964 CHEVY 1/2 C/10 FLEET  1981 CHEVY 1/2 C/10 FLEET 1995 DODGE 1500 V6 FLEET EAST http://www.flickr.com/photos/bigasspimp/?saved=1 |
|
|
|
10-18-2004, 10:55 PM
|
#2 |
|
17's too small
Join Date: Oct 2004
Location: Las Vegas, NV
Posts: 335
|
i can not understand you english? u joints are in the drive shaft. i have lots of pictures, "but you no maka since". i think i just understood your english. i was reading a just as an a, and you mean A frame. my bad. i think you might be asking about the u bolts that hold the lower contol arm on. if you mean them - there is a locating stud on the crossmember that fits into a hole on the lower control arm. here is a good photo.
__________________
68 C10 SWB SS 5 lug power disc brake conversion 2.5 inch drop spindles van tilt column Air Ride Technologies Cool Ride air bag kits Performance Online tubular upper control arms and shock relocator kits ECE super track panhard bar 1 piece side windows |
|
|
|
|
10-21-2004, 05:36 PM
|
#3 |
|
PIMPING RIDES
Join Date: Sep 2004
Location: SPRING,TEXAS
Posts: 296
|
Thanks
with that pic you answered my question
__________________
1964 CHEVY 1/2 C/10 FLEET 1981 CHEVY 1/2 C/10 FLEET 1995 DODGE 1500 V6 FLEET EAST http://www.flickr.com/photos/bigasspimp/?saved=1 |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
