does someone make an original style starter for a 168 tooth flywheel?

[JWG]

I'm installing a Ramjet 350 into my '65 C10. The Ramjet has a one piece rear seal so it uses a special flywheel which is 168 tooth. Does someone make an original stye starter, but for a 168 tooth flywheel, or will I have to change my flywheel to a 153 tooth?

[JWG]

or better yet... any issues with using my block mounted mini starter that's already on my ramjet with the factory bell housing that normally would use a bell housing mounted starter?

[JWG]

Originally Posted by JWG

or better yet... any issues with using my block mounted mini starter that's already on my ramjet with the factory bell housing that normally would use a bell housing mounted starter?

actually I just found some info online that answered my question

The cast iron bellhousings with flange mounted starters can be used on all V8's 1962-on. These can be used with block mounted starters by grinding the lower portion of the housing to clear the block mounted starter casting.

source:
http://www.novak-adapt.com/knowledge...shift_info.htm