Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
09-07-2013, 05:44 PM | #1 |
Registered User
Join Date: Sep 2013
Location: Spring grove pa
Posts: 14
|
Tire question?? And ratio?
Hi, I'm new to this forum. I have a 1987 silverado v10 with a 350 tbi. It has a 700r4 tranny and np08 transfer case. I just recently put 3:73 gears in. I want to put 35s on and wonder if it will have good power for wheelin and towing. So is this a good setup? And I also want somewhat good gas mileage.
Posted via Mobile Device |
09-07-2013, 06:47 PM | #2 |
Registered User
Join Date: Jan 2013
Location: Jasper, IN
Posts: 948
|
Re: Tire question?? And ratio?
That is a gair high because of the od and 35's. but will help with gas. The 700 is a good tranny just weak so be careful. The 208 is stout just watch for chain wear. You git a good setup could always change axle's to somethin lower, but you'll give up gas. Drive it, see how it stacks up. I think you will do about as good as ya can just keep the foot outta it lol.
Posted via Mobile Device
__________________
When in doubt, throttle it out! 1974 Chevrolet Custom K20 2005 Ford Ranger Edge 1985 Chevrolet Custom Deluxe C10 |
09-07-2013, 08:07 PM | #3 |
Registered User
Join Date: Feb 2012
Location: Big Valley. Alberta
Posts: 674
|
Re: Tire question?? And ratio?
My 82 K25 has same gearing as yours,it's on 35s with the 833OD tranny behind a 6.2. This combo works pretty well so far,if I get into mud or snow just throw it into low range.You should be ok with the 350,it will probably have more jam than my 6.2..
Posted via Mobile Device
__________________
1977 Chev C30 454/465/14ff DRW 1974 Chev C20.350/465/14ff " Rock n Roll ain't noise pollution" |
09-07-2013, 08:28 PM | #4 |
Registered User
Join Date: Sep 2013
Location: Spring grove pa
Posts: 14
|
Re: Tire question?? And ratio?
Thanks
Posted via Mobile Device |
09-08-2013, 01:40 AM | #5 |
Registered User
Join Date: Sep 2010
Location: Lake Tahoe, Nevada
Posts: 755
|
Re: Tire question?? And ratio?
I would say it's a hair tall for towing, depending on your load, but not much. If I was designing from scratch I would have chosen 4.10, so your 3.73 really isn't too far off. I certainly wouldn't suggest going through the hassle of changing your gearing unless you're towing a rather heavy load on a regular basis.
__________________
I know a little about cars, but if you have a question about electricity or sport quads, I'm your man!!! |
Bookmarks |
Tags |
350, 35s, 3:73, 4x4, 87silverado |
|
|