![]() |
![]() |
#1 |
Registered User
Join Date: Mar 2011
Location: MA
Posts: 354
|
GM throttle stud
OK hopefully someone has been down this road before. I am looking for a throttle bushing and stud that will fit the larger .500" hole in a Holley throttle bracket. I have a throttle stud from Holley that has the 7/32" stud and 1/4-28 thread. I found a bushing that one side is threaded but for 1/4-20. I can't find a stud with a 1/4-20 thread. Does anyone know of any that will fit?
Thanks |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Oct 2015
Location: Ottawa, Ontario, Canada
Posts: 752
|
Re: GM throttle stud
Holley does sell studs for there carbs on there site. But if you want to make your own 1/4"by 20 thread rod from hard ware store cut to size.
__________________
![]() Was a 77 454 w/308 gear. Taken out 550 lbs. up front with motor clip change. |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Jul 2000
Location: North Texas
Posts: 3,465
|
Re: GM throttle stud
Picture? I have lots of throttle studs in a parts drawer, one of which might work.
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! |
![]() |
![]() |
![]() |
Bookmarks |
|
|