WTT: '59 Apache 1-Ton driver w/rust for 67-72 parts + cash (or just cash!)

[botboy]

Hi guys, posting this cause I think this forum gets way more traffic than the 55-59 board. Anyways, here's what I've got:

Just hauled this truck back from northern wisconsin. Truck is a '59 apache, clear wisconsin title I am going to transfer to myself at the DMV tomorrow. 4 on the floor, dad says the engine doesn't look like a 235 so I assume its the 283? Big inline 6 whatever it is. Starts and runs like a dream. Doesn't smoke at all. Clutch is in fair shape, doesn't slip. Eaton corporate rear end, I assume open carrier. Needs rust repair in the door panels, fenders, cab corners, and floor. Frame is straight and solid. Electronics all work fine, no radio, gauges look good. Reads 34k on odo (assume that means 134k).

I want $625 for it, if you want to give me cash.

Otherwise, I want to trade for a negotiable amount of cash and the following parts for my '72 C10 Cheyenne 2WD:

- 3.73 or 4.11 posi carrier with gears for 12-bolt.
- a descent (driver) steel bed floor)
- a non-ac cab in good shape
- a front bumper (chrome) in good shape
- front fenders not rusted out not dented
- Hood from a '67 or '68
- Hood hinges, tight ones
- NV4500 or SM465 or ? prefer a 5-speed
- NV4500 hydraulic slave bellhousing
- Newer GM truck hydraulic master clutch setup

[botboy]

pic of truck

[stllookn]

Too bad you are not closer...that would be a done deal...my daughter wants a '59.

[botboy]

could meet you close to halfway....$.80/loaded mile