|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-22-2004, 01:06 PM
|
#1 |
|
urban fourwheelin
Join Date: Aug 2002
Location: Seattle
Posts: 1,007
|
how to remove wiring harness from fire wall
How do I remove the engine and front light harness from the fuse block? I just got a new harness and can't figure out how to take it apart. I all ready removed the bolt from the middle, what next?
thanks red72
__________________
1972 K5 Blazer with Cummins 4BT, NV4500 swap in the parts gathering stage. |
|
|
|
05-22-2004, 01:16 PM
|
#2 |
|
Registered User
Join Date: May 2004
Location: hope,british columbia
Posts: 18
|
Did you remove the screws on the fuse panel side, I think there is two or three.
|
|
|
|
|
05-22-2004, 01:34 PM
|
#3 |
|
urban fourwheelin
Join Date: Aug 2002
Location: Seattle
Posts: 1,007
|
i didn't Know that there were screws on the inside, That would explain it.
thanks red72
__________________
1972 K5 Blazer with Cummins 4BT, NV4500 swap in the parts gathering stage. |
|
|
|
|
05-22-2004, 03:27 PM
|
#4 |
|
Registered User
Join Date: Oct 2003
Location: Central Vermont
Posts: 8,537
|
Two screws inside and one bolt outside...and pull.
The harness on the engine side of the firewall is two seperate half's, one overlays the other. |
|
|
|
|
05-22-2004, 04:52 PM
|
#5 |
|
urban fourwheelin
Join Date: Aug 2002
Location: Seattle
Posts: 1,007
|
thanks guys
__________________
1972 K5 Blazer with Cummins 4BT, NV4500 swap in the parts gathering stage. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
