|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-12-2004, 07:02 PM
|
#1 |
|
Old Duffer
 
Join Date: Mar 2003
Location: Maine
Posts: 1,822
|
WTB '68 C20 Frame bracket for track bar
I'm looking for the frame bracket for the outer end of a '68 C20 factory dually track bar. This bracket has four rivets that go up through the frame flange (two on either side of the track bar eye,) and one rivet that runs horizontally through the frame face about 1" above the flange.
I've looked at several frames in my area and the standard track bar bracket is much smaller. Thanks in advance...
__________________
'68 Short C20 Flatbed Dually w/ 292 4bbl, Langdon cast headers, and WC T5 trans. '81 G10 Shorty Van "Good judgement comes from experience, and a lot of that comes from bad judgement." Will Rogers "Under promise, then over achieve." |
|
|
|
| Bookmarks |
|
|
Linear Mode
