|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-28-2005, 08:17 PM
|
#1 |
|
Oh,you can't buy that new
 
Join Date: Apr 2000
Location: Pennsville,N.J. 08070, USA
Posts: 2,039
|
F/S ,plastic gauge housing for tach
A few of you guys know that I occassionally redo these tach dashes very thoroughly. I have a BARE plastic gauge housing here that was for a factory tach with the small fuel gauge in the lower left corner. it accepts the electric oil pressure gauge so it's for 78-83ish only. It WAS a 1978 dash. the lower guide is broken off that the cable to move shift indicator rides through. I know a way to doctor that once it is installed that works fine, but i can't sell a unit like this after I dump a lot of time/money into it. You will not need that guide if you have a stick shift truck. the useless left side tab is broken off also.
$20 plus shipping for the housing. $55 if you want a decent printed Circuit with it. P/N 25017327 Paypal or money orders only, thanx , DAVE
__________________
"been there, done that, ruined the T-shirt". 2007 LBZ GMC Sierra, ECSB 2006 LM7 RCSB Silverado 98 Vortec project. 94,3500,6.5L 4L80 81 SWB GMC POS finally gone  73 Pinto, stock, w/CragarSS's-eww  LOTS of Cummins trucks. |
|
|
|
02-14-2005, 04:36 PM
|
#2 |
|
Oh,you can't buy that new
Join Date: Apr 2000
Location: Pennsville,N.J. 08070, USA
Posts: 2,039
|
one time to top
__________________
"been there, done that, ruined the T-shirt". 2007 LBZ GMC Sierra, ECSB 2006 LM7 RCSB Silverado 98 Vortec project. 94,3500,6.5L 4L80 81 SWB GMC POS finally gone 73 Pinto, stock, w/CragarSS's-eww LOTS of Cummins trucks. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
