|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-08-2005, 07:36 PM
|
#1 |
|
'70 GMC C-25 LWB
Join Date: Oct 2004
Location: Binghamton, N.Y.
Posts: 273
|
Cutting springs on my 3/4 ton
Can I cut my springs for a 1" drop? I have 3" drop spindles and a rear flip kit. I want a 4-6 drop so i was going to cut my springs 1in. Is it possible or do I have to buy 1" or just go 2". Thanks.
__________________
1970 GMC C-25 LWB (middle of frame up) 5-7 drop with 3in drop spindles, flip kit with blocks and still keeping the 3/4 ton. Shaved drip rails and marker lights, rear roll pan, cowl induction hood. 1987 Camaro z28 350, vortec 305 heads. 10:1 comp, t5 trans. Street terrrorizer. 1988 Monte Carlo (Super Stock ashpalt race car) My Truck |
|
|
|
05-09-2005, 03:46 PM
|
#2 |
|
AttentionDeficitDisorder
Join Date: Mar 2005
Location: COLORADO
Posts: 600
|
hey, can you post part numbers and tell me where you got your spindles and flip kit, im looking for drop parts for my 82 crewcab shortbed 3/4 ton
thanks john |
|
|
|
|
05-09-2005, 11:23 PM
|
#3 |
|
Registered User
Join Date: Aug 2002
Location: Kent, Wash
Posts: 53
|
3/4 tonDropped Spindles
I just did the same thing to my '71, I had to raise it up to fit my 285/60R16 BFG's all the way around. I got the spindles from GMC Pauls and they fit without any grinding.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
