|
06-08-2005, 08:36 PM
|
#1 |
|
Registered User
Join Date: Jun 2003
Posts: 104
|
what seats...
can i use in my 72 c-10? i have read many articles where people have used buckets from small foriegn cars but the all look like you would have to fab. quite a bit. not looking for perfect bolt in, hell i own a drill. is there anything that i could just set in place and drill me some bolt holes?
|
|
|
|
06-08-2005, 09:25 PM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
dodge vans thru the mid to late 80's used these types of buckets, they're the same basic frames as used in the 71-72 chevy pickups.they run less than $25 each in the pull-and save by me . taken to a local upholstery shop for some foam reworking and new covers they'll look real close to the factory seats at a fraction of what the resto-guys are asking. you can simply cut the van base to the proper height and bolt in
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY Last edited by cdowns; 05-12-2006 at 08:06 AM. |
|
|
|
|
06-08-2005, 09:28 PM
|
#3 |
|
Senior Member
Join Date: Jan 2005
Location: LAX area, So Cal
Posts: 499
|
I followed Putter's lead and used the second row seats from a Tahoe/Suburban (circa 1999).
Some pics in this thread Pretty easy install.
__________________
1972 Suburban C20 454/TH700R4, eaton-corporate 4.10 (looking for 3.7) Sold: 71 Cheyenne 20 Installed a 99 5.7L L31/4L60E from Suburban 1500 (2005) |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
