|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-07-2005, 05:13 PM
|
#1 |
|
Registered User
Join Date: Nov 2005
Location: San Marcos, Tx
Posts: 62
|
Seals- Where do they go?
I am starting to put back my factory tilt steering column in my recently repainted cab. Everything was stripped off. I previously bought all the seals and gaskets from ChevyDuty some time ago, and it seems that I dont know where a few go. Could somebody help? I know the gasket on the far left is the large gasket that seals the column to the outside firewall, but I am at a loss for the other (3). They call the 2nd from the right a steering column felt seal. It does fit over the bottom shaft where the spline is located but a spring goes there. Any ideas?
Thanks, |
|
|
|
11-07-2005, 05:23 PM
|
#2 |
|
The LuvShack Garage
Join Date: Jan 2004
Location: Maple Grove, TN (West Side)
Posts: 30,475
|
Re: Seals- Where do they go?
 2 THE BOARD FROM WEST 10-UH-C   I HAVE NO IDEA, NEVER DONE THAT MYSELF EITHER 
__________________
Owner/Op: "TN Classic Transport Carriers" The Toy: "Square Vette" 72 Hybrid Blazer Toy Barn: "LuvShack" 40 x 60 x 20 Shop Big Piggy: "Goliath" 07 Kodiak C4500 Lil Piggy:"Maddy" 88 Silverado 3500 Hauler: "Feathers" 14 Aluma 8218T |
|
|
|
|
11-08-2005, 02:45 PM
|
#3 |
|
Registered User
Join Date: Nov 2005
Location: San Marcos, Tx
Posts: 62
|
Re: Seals- Where do they go?
Anyone replaced these??
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
