Crank Pulley Questions???

[rodstored-72]

merry christmas everyone!
i hope everyone's christmas was a fruitful one! well i didn't get too much done on the truck, but did get to see some family that we hadn't seen for awhile. well what i did get done on the truck was that i cleaned the serpentine belt system that i got from a 1992 burb. and tried to mount it.. but once again i ran into a few problems. i was hoping that some of you out there could maybe give me some insight to some fixes for me! the first problem is that the crank pulley (harmonic balancer pulley) from the '92 burb doesn't fit the the balancer for my engine. the new pulley has a lip at the center & my balancer is flat at the center?? does anyone know if i can get a serpentine pulley to fit the front of a 1972 chevy 350 sbc engine?? the last question is probably going to be easy for you real chevy engine guys when i do get the right pulley or set up to run a serpintine belt setup on my '72 chevy p/u i was wondering what the bolt size & length is for the crank pulley (harmonic balancer pulley) is??? i am under the impression that the bolts from my '92 burb pulley setup are metric & the '72 chevy balancer is standard so i was hoping the board could give me the bolt size & length needed to bolt the pulley to the balancer??


thanks for all the input you guys have helped me in the past & future!!!!!


rodstored-72

[FormerMember]

Why not run the balancer from the burb?