|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-15-2006, 11:59 PM
|
#1 |
|
Registered User
Join Date: Dec 2005
Location: SJC
Posts: 158
|
SB engine hoist leveler attachment locations?
I'm getting ready to install a 350/700r4 combo into my C20. I'm curious whats' the best method to stab engine / trans. Right now I have the engine hoist load leveler attached to the front and back of the cyl. heads ( 4 chains ) w/ grade 8 bolts. Reason I went this route is because I installed the intake man. while the eng is still on the stand.
Recommendations / experiences?
__________________
___________ Greubin '71 C20 custom - GM Crate 350CI/290HP, BTO 700R4 level II, Qjet, and HEI 
Last edited by Greubin; 04-15-2006 at 11:59 PM. |
|
|
|
04-16-2006, 12:10 AM
|
#2 |
|
Senior Member
Join Date: Dec 2004
Location: Southern Pines NC
Posts: 3,853
|
Re: SB engine hoist leveler attachment locations?
Thats pretty much it. I prefer to install them apart because it is easier but takes more time.
|
|
|
|
|
04-16-2006, 12:12 AM
|
#3 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Re: SB engine hoist leveler attachment locations?
I agree, it's nothing to bolt the two together in the truck, but I think that's just personal preference.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
