|
08-10-2002, 11:49 AM
|
#1 |
|
GYRO GEARLOOSE
Join Date: Jun 2000
Location: Nevada City, CAEverett, WA
Posts: 361
|
Disc brake calipers
On my way to the Pull-a-Part to finish pulling the front x-member from a 81 C-10. It is complete except for one of the calipers, and there are no other C-10's there, but some vans. Are the calipers from any other GM product the same as the C-10's (thick rotors)?
Also, what is the size of the allen wrench to pull the calipers?
__________________
Nevada City, CA Everett, Washington 57 3/4 rat, 235, 3spd 66 C-10 Panel, SWB. 350 from '68, 200R4 tranny, 3.07 rear ratio, restoring 68 C10 LWB 350 4spd, 4.56 rear dump runner 82 Camaro, 305, THM-200-R4 84 Monte Carlo 305 TH350, land tuna 85 Tercel SW, snow runner DISGRACED OUTLAW MEMBER OF THE DRUM BRAKE CLUB |
|
|
|
08-10-2002, 08:22 PM
|
#2 |
|
GYRO GEARLOOSE
Join Date: Jun 2000
Location: Nevada City, CAEverett, WA
Posts: 361
|
Nevre mind, Vans are the same. A lot of cars have what looks like the right ones, but for thinner discs. Getting the clip out would have been a lot easier without an engine in, but the real ***** was hauling it to the front door of the yard!
__________________
Nevada City, CA Everett, Washington 57 3/4 rat, 235, 3spd 66 C-10 Panel, SWB. 350 from '68, 200R4 tranny, 3.07 rear ratio, restoring 68 C10 LWB 350 4spd, 4.56 rear dump runner 82 Camaro, 305, THM-200-R4 84 Monte Carlo 305 TH350, land tuna 85 Tercel SW, snow runner DISGRACED OUTLAW MEMBER OF THE DRUM BRAKE CLUB |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
