|
09-21-2007, 09:31 PM
|
#1 |
|
Friday's Toy
 
Join Date: Nov 2006
Location: Ovilla, TX
Posts: 574
|
Buddy buckets
Here's what I have been thinking. I have factory buddy buckets that have been recovered in great condition. What I want to do since the seat belts are in factory specs, not incorporated into the seat and all, is to make them tilt forward. I need the extra storage under the seals that is easily accesible. I want to leave the 2 front bolt down straps and remove the 2 rear, same with my console. With that I want to install 2 latches per section drivers/console/passenger on the rearward mounts. This way I can unlatch the rear of the seat and have them pivot towards the dash all 3 sections. The main reason this came up was due to my 10 disk changer I have yet to locate in the truck. Does anyone see any problems I may run into with this mod?????Mikey
__________________
68 C10, SWB Fleetside with a 454, Turbo 400 and 4.11 posi....Exxon/Mobil loves me. 2009 Jeep Rubicon 2011 Powerstroke FX4 (totaled) 71 C10, SWB Fleet with factory tilt 72 LWB C10, 350 700R4 with factory tilt |
|
|
|
09-21-2007, 10:05 PM
|
#2 |
|
SLOW BUT SURE,BUT CLOSER
Join Date: Feb 2002
Location: eleanor wv usa
Posts: 3,092
|
Re: Buddy buckets
Installin' seats in these is unlimited, plan it out and do it.
__________________
69 C-10, OWNED 35YRS... 350 over 30, 350 Turbo, 3:73 Posi P/S, P/B Black with red and black int. ''LOVE THESE OLD ''TRUCKS.......  
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
