Throttle linkage HELP NEEDED ASAP - The 1947 - Present Chevrolet & GMC Truck Message Board Network

64Magoo · 05-18-2008, 07:01 AM

I have a '64 with a 283 and I just put a brand spankin' new 4 barrel Edelbrock carb on it today. The linkage is the rod type with the two springs and the rod is too short (when the linkage is loosely attached to the carb it is in the WOT position). I bought a kit to switch over to a cable linkage but is there an easier way? I don't have much time to lend to this problem do to the fact that it's my DD and I have to go to work tomorrow.

05-18-2008, 07:01 AM	#1
64Magoo Registered User Join Date: Jan 2008 Location: Bakersfield CA Posts: 265	Throttle linkage HELP NEEDED ASAP I have a '64 with a 283 and I just put a brand spankin' new 4 barrel Edelbrock carb on it today. The linkage is the rod type with the two springs and the rod is too short (when the linkage is loosely attached to the carb it is in the WOT position). I bought a kit to switch over to a cable linkage but is there an easier way? I don't have much time to lend to this problem do to the fact that it's my DD and I have to go to work tomorrow.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.