Complete Bracket And Pulley Setup - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mosesburb · 12-06-2008, 03:42 AM

Complete bracket and pulley setup for a small block with power steering and A/C. Came off of my '72 Suburban. It is getting a Cummins, but I glass beaded all of these and painted with the correct low gloss paint before the final decision on which motor it was getting was made, so they are ready to run. They are in very nice condition--appear to be straight and the bolt holes have no galling around them.

Now, not having installed the small block, I never mounted these up, so I am assuming it is complete. What is pictured is what I have for it.

$175 + ship (Reasonable offers will be considered)

Please respond in thread.
Thanks!!

12-06-2008, 03:42 AM	#1
mosesburb I had a V-8 Join Date: May 2003 Location: Phoenix AZ Posts: 1,116	Complete Bracket And Pulley Setup Complete bracket and pulley setup for a small block with power steering and A/C. Came off of my '72 Suburban. It is getting a Cummins, but I glass beaded all of these and painted with the correct low gloss paint before the final decision on which motor it was getting was made, so they are ready to run. They are in very nice condition--appear to be straight and the bolt holes have no galling around them. Now, not having installed the small block, I never mounted these up, so I am assuming it is complete. What is pictured is what I have for it. $175 + ship (Reasonable offers will be considered) Please respond in thread. Thanks!! __________________ 1972 K20 Suburban, 5.9L Cummins, Banks Power Pack, NV4500HD, NP205, H.A.D., D60/14FF ARB Link To Build: HERE. Last edited by mosesburb; 12-20-2008 at 12:56 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.