|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-24-2010, 03:20 PM
|
#1 |
|
Registered User
Join Date: Dec 2003
Location: nor cal
Posts: 219
|
Bed to Cab measurement
Hey everyone,
Putting my fleet-side bed back on my '69. Trying to figure out the gap between the cab and the bed. If someone has the measurement that would be a great help. Thanks CST350 |
|
|
|
07-24-2010, 03:49 PM
|
#2 |
|
20' Daredevil (Ret)
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,682
|
Re: Bed to Cab measurement
From the top of the front bed panel to the cab (just below the rear window) is right at 1" on my '72.
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
|
07-24-2010, 06:30 PM
|
#3 |
|
Registered User
Join Date: Dec 2003
Location: nor cal
Posts: 219
|
Re: Bed to Cab measurement
Thanks Stocker!
|
|
|
|
|
07-24-2010, 07:27 PM
|
#4 |
|
Active Member
Join Date: Jul 2007
Location: Centrally located between Houston, Austin and Waco. BCS area.
Posts: 7,947
|
Re: Bed to Cab measurement
I used two 1" boards - one on each side between the cab and bed and pushed the bed forward. Then I eyeballed the left to right by looking from the back of the bed towards the front.
The reason for the two boards is that it's easier to keep the distance the same while adjusting for left to right. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
