|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-26-2003, 08:38 AM
|
#1 |
|
Registered User
Join Date: Mar 2002
Location: Agua Dulce, Ca. usa
Posts: 179
|
283 heads on a 327 motor
I am getting a free rebuilt but left in the weather with the heads off a 283 engine(block badly rusted), someone is giving me a 327 no heads. So I will have a 327 block and rebuilt 283 heads, can this combonation work for a working motor. Anything else to check or watch for Ed ke6bnl
__________________
Ed ke6bnl Agua Dulce 70 S.E. Los Angeles 70 Chevy short bed 1948 F3 ford pu 1949 F1 stock V8 flathead 3 on floor 1950 F1 pu street rod 1948 F6 Ford Dually/350sbc no bed stock trans&rear 1972 El Camino 4" chop 1953 Chevy 3100 2b daily driver 1970 SB 4X4 400ci 6in lift |
|
|
|
03-26-2003, 08:43 AM
|
#2 |
|
Registered User
Join Date: Dec 1999
Location: Old Mission, MI, USA
Posts: 2,507
|
Should work fine. A lot of the factory heads were used in both applications.
__________________
Tim |
|
|
|
|
03-26-2003, 11:00 AM
|
#3 |
|
Account Suspended
Join Date: Mar 2001
Location: Virginia Beach, Va. U.S.A.
Posts: 15,320
|
Yes, they will work fine. One thing though, some 283's came with 1.72/1.50 valve heads. You won't get much top end out of these. On the other hand...some came with camel hump heads.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
