NC swb upper bed molding

[67/72junkie]

I have 2 good driver condition upper bed moldings.not beat up and and scared.Both had 2 small screw holes in the middle where someone added screws.They are in the black painted part.I put a little epoxy on the back of each one and touched up with black paint..Very good for a driver that someone doesn't want new that makes the rest of the older trim look bad.$65 plus $25 to ship.I just shipped 2 to Texas and it cost $15 priority and $10 for pvc to ship them in.I will post pic in a little while.

[VA72C10]

I'll take them pending pictures. Thanks

[67/72junkie]

trim is good for a daily driver with original trim.1 or 2 pieces of new trim looks bad to me.It either needs to be all original or all new to look right.I rinsed it off with the hose and a soft brush .I then put a small piece of tape over the front of the screw holes and a dab of epoxy on the back.I taped off the center and sprayed the black to blend them in.one pic shows close up of screw hole after epoxy and one shows epoxy on back will not inter fear with clips.I did not polish them any.I think they will shine up pretty good after the paint has cured.I took pic of the hole that stood out the most up close..you have to get up close to see it.

[VA72C10]

I'll take them. I have a couple complete sets of decent used LWB molding and would like a swb driver's set...

[67/72junkie]

Thanks,I will go get pvc this afternoon and get send them out in the morning.