|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-22-2011, 06:05 PM
|
#1 |
|
Registered User
Join Date: Dec 2009
Location: Snohomish, Washington
Posts: 1,187
|
Floor hump for the gas tanks, Can it be cut and lowered?
Just like the title says, The hump for the gas tanks that the bench seat sits on can it be cut and lowered to match the rest of the floor? I want to use seats that are 36inches tall and since im removing my gas tanks and running a cell in the very back I was wondering if I could drop that section so the seats dont sit up to high.
|
|
|
|
05-22-2011, 07:46 PM
|
#2 |
|
Robert Olson Transport
 
Join Date: Oct 2002
Location: recent transplant to NC USA
Posts: 20,277
|
Re: Floor hump for the gas tanks, Can it be cut and lowered?
there would prolly be some fabrication for the rear cab mounts involved too
__________________
Bob 1951 International running on a squarebody chassis "If a man's worth is judged by the people he associates himself with, then i am the richest man in the world knowing some of the fine people of this board" http://67-72chevytrucks.com/vboard/a...t.php?f=25&a=9 (you can review the site rules here!) PM Me for your vehicle/parts hauling needs in the North East US or see my Facebook page Robert Olson Transport Live each day to the fullest.. you never know when fate is going to pull the rug out from under you... I hate cancer!! |
|
|
|
|
05-22-2011, 08:02 PM
|
#3 |
|
Registered User
Join Date: Jul 2007
Location: Ontario Canada
Posts: 1,006
|
Re: Floor hump for the gas tanks, Can it be cut and lowered?
There is a thread where one of the members dropped the floor to put newer seats in
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
