|
05-28-2011, 10:34 PM
|
#1 |
|
Registered User
Join Date: Jan 2010
Location: Prairie Ms
Posts: 2
|
Help!
I just got done putting on a set of drop hangers and shackles on my 85 swb and when I went to bolt my springs up, my drive shaft bottoms out in the tranny. Is this a common problem or did I do something wrong? The hangers and shackles are both 2" drops
|
|
|
|
05-28-2011, 11:25 PM
|
#2 |
|
Registered User
Join Date: Jun 2008
Location: Lubbock, TX
Posts: 2,047
|
Re: Help!
You took all the slack out of it when you lowered it. Gonna have to get your driveshaft shortened. Sorry.
|
|
|
|
|
05-28-2011, 11:34 PM
|
#3 |
|
Registered User
Join Date: Jan 2010
Location: Prairie Ms
Posts: 2
|
Re: Help!
Thanks man. Figured that's what the deal was but was hoping it wasn't. Oh well....
|
|
|
|
|
05-28-2011, 11:39 PM
|
#4 |
|
Registered User
Join Date: Sep 2010
Location: los angeles
Posts: 1,130
|
Re: Help!
There were brackets in a flip kit I used that positioned the rear wheel back, to avoid that problem...the only thing was that I didn't like the look because the wheel wasn't centered in the wheel housing any more.
I'm in the middle of a tranny swap, and took the time to drill my flip kit brackets, so the wheel was centered...I had to get a new driveshaft anyway, and I thought I'd center the wheel. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
