350 SB rebuildable core 4 sale - The 1947 - Present Chevrolet & GMC Truck Message Board Network

gchemist · 04-02-2003, 03:54 AM

'93 GM crate 350 iron block - 4 bolt casting 100660036

This is a two piece seal block. Block was removed from a K-10 due to lack of power. When I tore it down, I found a cracked valve in the #7 piston. There is no visible damage to the cylinder or the piston. My guess is that the head came with a broken valve installed. This is a bare block with a stock crank. I do have the original pistons and rods available and included if wanted. The block is on a brand spanking new stand too. The stand and the drip pan can be included too. Block is located in Austin, Texas. I can deliver locally for no charge. I can work for delivery outside of the Austin, TX area. Asking $175.00 for all. I had planned for a 355 rebuild but my mom bought me a 94 single seal block. Since this block has provisions for a roller cam, I'll be using the new block instead.

Low87 · 04-02-2003, 10:07 AM

You wouldn't happen to be going to the swap meet in Dallas in a couple weeks would you???

gchemist · 04-07-2003, 07:19 PM

Greg,
When is the Dallas meet? If you're interested I might be able to swing on up.

04-02-2003, 03:54 AM	#1
gchemist BAD BOW-Silverado XST Join Date: May 2000 Location: Senior Member from Austin, TX Posts: 6,431	350 SB rebuildable core 4 sale '93 GM crate 350 iron block - 4 bolt casting 100660036 This is a two piece seal block. Block was removed from a K-10 due to lack of power. When I tore it down, I found a cracked valve in the #7 piston. There is no visible damage to the cylinder or the piston. My guess is that the head came with a broken valve installed. This is a bare block with a stock crank. I do have the original pistons and rods available and included if wanted. The block is on a brand spanking new stand too. The stand and the drip pan can be included too. Block is located in Austin, Texas. I can deliver locally for no charge. I can work for delivery outside of the Austin, TX area. Asking $175.00 for all. I had planned for a 355 rebuild but my mom bought me a 94 single seal block. Since this block has provisions for a roller cam, I'll be using the new block instead. __________________ Gerardo a.k.a. Mad Chemist Silverado XST videos

04-02-2003, 10:07 AM	#2
Low87 been here longer than Liz Join Date: Feb 2000 Location: Broken Arrow, OK Posts: 2,437	You wouldn't happen to be going to the swap meet in Dallas in a couple weeks would you??? __________________ ~Greg~ Mac's Garage '87 SWB 6/8 drop "Piso" '08 CCSB Silverado DD the departed '89 GMC K5 Jimmy 4x4 "Rusty Nuts" '77 Chevy K5 Blazer 2wd '83 Chevy stepside "You get what you pay for" - Mike 'swervin ervin' Ervin

04-07-2003, 07:19 PM	#3
gchemist BAD BOW-Silverado XST Join Date: May 2000 Location: Senior Member from Austin, TX Posts: 6,431	Greg, When is the Dallas meet? If you're interested I might be able to swing on up. __________________ Gerardo a.k.a. Mad Chemist Silverado XST videos



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.