|
08-21-2011, 11:25 AM
|
#1 |
|
Registered User
Join Date: Dec 2009
Location: Fort Mill, SC
Posts: 4
|
75 Seatbelt question
We are wanting to put a shoulder style seat belt in our 75 GMC.... Any ideas on how to get the cap off that is covering the factory mounting point? My assumption is that I will find a threaded location behind the factory applied cap?
Also, know the bolt size that goes with it? Thanks in advance - dan |
|
|
|
08-21-2011, 02:57 PM
|
#2 |
|
Registered User
Join Date: Jan 2011
Location: San Bruno, CA.
Posts: 348
|
Re: 75 Seatbelt question
Take a small flat head screw driver and try prying off the cap. I have a magazine with an article in it about this, so yeah you SHOULD find a threaded location behind the cap. Post some pics of it so I can try to help you more. As for the size, I can't exactly remember it since I replaced mine a while ago.
Posted via Mobile Device |
|
|
|
|
08-21-2011, 08:48 PM
|
#3 |
|
Registered User
Join Date: Jul 2008
Location: Show low,az
Posts: 808
|
Re: 75 Seatbelt question
We had a 73 that we installed shoulder belts in. We popped the cap off with a screwdriver and took a seat belt assembly out of a 87 and the bolt went right into the 73 simple as that. The bottom assembly where the belt coils into was a little bit different but it still worked it just did not seem to fit the floor contour as well.
__________________
1978 C10 Silverado Big 10 350/350.. play toy 1990 V1500 Suburban 350/700r4..Daily driver 1987 K10 Silverado 383/400.. Wife's rig WRECKED! 1989 V2500 Suburban 350/400.. SOLD! 1974 C10 Custom10 LWB 350/350.. SOLD! 1974 C10 Custom10 SWB 350/400.. SOLD! 1999 Silverado Z71 LS1.. Wife's rig WRECKED! On the hunt for a new project....... I'm a Chevy guy.....I'm just not a "NEW" Chevy guy. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
