|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-31-2011, 06:48 PM
|
#1 |
|
Registered User
Join Date: Jun 2010
Location: Libby, MT
Posts: 163
|
Has anybody seen this type of locking hubs?
Hello everyone! I was at the wreckingyard by my house and I found a set of these hubs... They are 19 spline and will fit my Dana 44. They are the external type. They are 1/4 turn, and they can engage/disengage either clockwise or counterclockwise. The direction you turn them does not matter, they work either way. Thanks in advance for any replies! I want to put these on my truck, but before I do I want to know if there is anybody that sells replacement parts for them, or if I should just rebuild my Mile Marker hubs and put new wave springs in them
Thanks!!! 
__________________
Rich My first truck!!  1976 Chevy 3/4 ton Camper Special and a 1985 GMC body. Has a 350, 4 BBL Edelbrock, with a Turbo 350, and NP205 T-case.
Last edited by 76/85 Truck; 12-31-2011 at 06:56 PM. |
|
|
|
12-31-2011, 08:04 PM
|
#2 |
|
Registered User
Join Date: Jun 2010
Location: Libby, MT
Posts: 163
|
Re: Has anybody seen this type of locking hubs?
They came off a 70's F*rd... The truck had front drum brakes if that helps... I think it is still a Dana 44 front end on the F*rd though... Because they fit my 76 Dana 44.
__________________
Rich My first truck!! 1976 Chevy 3/4 ton Camper Special and a 1985 GMC body. Has a 350, 4 BBL Edelbrock, with a Turbo 350, and NP205 T-case.
|
|
|
|
|
| Bookmarks |
| Tags |
| dana 44, external, hubs, locking |
|
|
Linear Mode
