|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-06-2012, 08:26 PM
|
#1 |
|
Registered User
Join Date: Apr 2012
Location: Farmington,Mn
Posts: 24
|
Truck not sitting level after drop?
I just finished my suspension in my 63 and the passenger side front sits about an inch higher than the drivers side. I did a disc brake conversion up front with 2.5" drop spindles and 1" drop springs. 4" drop springs in rear. Why would it sit unlevel?
Posted via Mobile Device |
|
|
|
05-06-2012, 08:40 PM
|
#2 |
|
Proud Americano
 Join Date: May 2008
Location: CORONA,CA
Posts: 98
|
Re: Truck not sitting level after drop?
make sure that the coil springs are sitting in the control arms properly.
__________________
Tattooed Cuban Trailer Trash. putting the cart before the horse since 1964. |
|
|
|
|
05-06-2012, 08:59 PM
|
#3 |
|
Registered User
Join Date: Apr 2010
Location: sacramento ca.
Posts: 1,038
|
Re: Truck not sitting level after drop?
X2 make sure the end's of the coil is sitting in the indent in the spring pockets on top and bottom..
__________________
Timmy D. "What that grinding noise?Don't worry about that it will eventually clearance itself!" 1966 chevy c10 Build Thread:http://67-72chevytrucks.com/vboard/s...d.php?t=485977 1954 ford customline H.A.M.B 54 Build Thread:http://www.jalopyjournal.com/forum/s...d.php?t=622142 |
|
|
|
|
05-07-2012, 05:43 AM
|
#4 |
|
Registered User
Join Date: Jul 2011
Location: Anderson, Texas
Posts: 535
|
Re: Truck not sitting level after drop?
Swap the springs side to side
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
