Bagged Suburban Guys??

[5150]

Where are you guys putting your tank and compressor at. Mine's been on schrader valves for a while and I'm about to install my Air Ride Technologies digital air gauge and sensors. Just trying to find the best place where it's not too loud.

[vectorit]

Check out the build area for the burbs, there are a couple builds in there that may help answer your question.

[kev2809]

heres what i did with a 5 gallon tank.

[IMG][/IMG]


little dusty...right now i have one comp but will be getting a dual pack before it hits the road. im going to make another bracket to hold 2 of them right where the single one is at now..

the tank bracket is (2) pieces of 2" square tubing welded togeter to raise it up..then its bolted to the frame. the cross plate is 3/16" plate that i bolted the air tank to. no way the tank would work with those brackets without raising it up..it barely clears now.

[Hart_Rod]

I mounted mine to the bottom of the rear floor between the gas tank and bumper.

[kev2809]

are those pics with the truck laid out?

[Hart_Rod]

Originally Posted by kev2809

are those pics with the truck laid out?

Kev are you talking about my burb?

[kev2809]

ya, just trying to reference how far that is from the ground when aired out.

[Hart_Rod]

Originally Posted by kev2809

ya, just trying to reference how far that is from the ground when aired out.

Kev - it's probably 8" off the ground when aired out. I'll try to take some good pictures the next time I get a chance.

[Hart_Rod]

Here's the best I can do right now. it's not quite as low as it appears because I have the front on jack stands.

[project 67 sub]

here is where i have mine mounted at. not exactly the quietest spot because i have the rear valves mounted directly to the tank, but then again my burb isnt exactly quiet anyways.... doesnt help that i dont have a rear floor lmao
but anyways its just another idea. oh! its a 9 gallon tank, and the rear valves will be getting relocated to below the rear floor once i build it. but the tank will most likely stay their.







and if you want an idea where to mount the front valves this is where i have mine at

[5150]

I ended up mounting the tank and compressor under the third door on the frame.
Posted via Mobile Device

[kev2809]

must have a skinny tank, mine wouldnt work there.

[bruin_d]

Might help...