|
11-05-2012, 12:10 PM
|
#1 |
|
resident wrencher
Join Date: Dec 2006
Location: ramona california
Posts: 720
|
Total newb question
Ok so I got a new to me 79 k10 it has manual looking hubs and a np203 with what I hope is a part time kit installed. Question 1 is how do I know it's got a part time kit and 2 how do I use the 4x4 it's in high with the hubs unlocked right now do I just lock the hubs and use hi loc ?
Posted via Mobile Device |
|
|
|
11-05-2012, 06:11 PM
|
#2 |
|
resident wrencher
Join Date: Dec 2006
Location: ramona california
Posts: 720
|
Re: Total newb question
Ok so I can do rear wheel only doughnuts in hi and hubs locked high loc I can climb up thing lo and low loc I go up any thing so I figure hi is normal 2 wheel driving. And all others are 4x
Posted via Mobile Device |
|
|
|
|
11-05-2012, 10:59 PM
|
#3 |
|
Registered User
Join Date: May 2009
Location: Pinehurst, Idaho
Posts: 311
|
Re: Total newb question
You will know it has a part time kit because if you unlock the hubs and put the transfer case in 4hi without a part time kit the truck will not move. In normal driving you use 4hi or 4lo. 4hi loc and 4lo loc are for offroad only.
|
|
|
|
|
11-06-2012, 12:10 AM
|
#4 |
|
resident wrencher
Join Date: Dec 2006
Location: ramona california
Posts: 720
|
Re: Total newb question
So I leave it in high as I drive when in park the front drive shaft will doing by hand. I lock the hubs and put in hi loc I can go pretty much any where lo seems just slower and lo loc I can go anywhere I'm pretty sure I can drive up a wall if I could get te rubber on it so with a part time kit hi and low are two wheel gears and hi lock and lo loc are four wheel ? Sorry for the newb questions I've never delt with full time cases or 203s
Posted via Mobile Device |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
