|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-26-2013, 05:26 PM
|
#1 |
|
Senior Member
Join Date: May 2004
Location: johnstown, NY
Posts: 2,393
|
A couple measurements please
Can I get a measurement of the space between the cab and the box header panel? Also the width between the bed rails on a fleet side. Thanks!
Posted via Mobile Device |
|
|
|
02-26-2013, 05:48 PM
|
#2 |
|
20' Daredevil (Ret)
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,728
|
Re: A couple measurements please
1"
66"
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
|
02-26-2013, 08:20 PM
|
#3 |
|
The Older Generation
  
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 25,818
|
Re: A couple measurements please
-
I try to keep all of my cab to bed clearances at 3/4". LockDoc
__________________
Leon Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles (My Dually Pickup Project Thread) http://67-72chevytrucks.com/vboard/s...d.php?t=829820 - |
|
|
|
|
02-26-2013, 08:56 PM
|
#4 |
|
Senior Member
Join Date: May 2004
Location: johnstown, NY
Posts: 2,393
|
Re: A couple measurements please
Thanks fellas!
Posted via Mobile Device |
|
|
|
|
02-26-2013, 11:46 PM
|
#5 |
|
20' Daredevil (Ret)
Join Date: May 2003
Location: Jefferson State
Posts: 13,728
|
Re: A couple measurements please
On a somewhat related note, my K20 flexes enough off-road that even with a 1" gap (original factory spacing), the RF bed corner contacts the rear of the cab, and has left a permanent impression.
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
