The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 10-11-2013, 03:28 PM   #1
USArmyCombatMedic
Registered User
 
Join Date: Oct 2013
Location: Rushford, MN
Posts: 23
Where does this connector go?

Hi all, I have an 87 Chevy R10 with a 5.7L 700 R4 just wondering if you guys know what this electrical connector goes to? Im sure the picture explains most of it but its a green wire running along the top of the firewall. At the end of the wire there is a black 90 degree angle connector with two prongs. I believe it is a female connector but not positive thanks in advance!
Attached Images
  
USArmyCombatMedic is offline   Reply With Quote
Old 10-11-2013, 03:37 PM   #2
bnoon
Registered User
 
Join Date: Jul 2012
Location: Des Moines IA
Posts: 1,250
Re: Where does this connector go?

Seems like the pressure sensor for the AC system was a green wire in that location, but my connector looked different on my old '86. Is there a connection already plugged into the AC drier right near there???
__________________
- 1981 Sierra 454, NV4500 swap
- 2006 Z06, 25k miles
- 1973 Nova - Project CarNova Virus on Youtube
bnoon is offline   Reply With Quote
Old 10-11-2013, 03:53 PM   #3
USArmyCombatMedic
Registered User
 
Join Date: Oct 2013
Location: Rushford, MN
Posts: 23
Re: Where does this connector go?

Thanks for the quick reply. So heres another pic. I think I included the one you were talking about. It was connected to the silver canister in the AC system. There is the 4 way connector on the AC box with a black wire, orange wire, and two blue wires. Then there is a relay looking box under the 4 way connector that has a one way purple wire shooting out of it. All of these are connected in the correct place minus the green one I just unplugged to give you a better look.

I have a feeling it goes lower since it is pretty dirty with gravel dust and such. I just cant find anything it would plug into. The only electrical things on that side of the engine that I know of are the start moter and solenoid and the engine knock sensor which are all correctly hooked up. I am confused :/ Thanks again!
Attached Images
 
USArmyCombatMedic is offline   Reply With Quote
Old 10-11-2013, 07:41 PM   #4
kalbert
Registered User
 
Join Date: Jun 2012
Location: Minnesota
Posts: 509
Re: Where does this connector go?

The wire draped over the evaporator box in the first picture is for the compressor clutch. It normally would run along the side of the valve cover to the compressor. It is probably very dirty and greasy from laying on the intake manifold next to a leaky valve cover gasket most of it's life.
kalbert is offline   Reply With Quote
Old 10-12-2013, 02:10 PM   #5
USArmyCombatMedic
Registered User
 
Join Date: Oct 2013
Location: Rushford, MN
Posts: 23
Re: Where does this connector go?

Thanks kalbert! After looking at the air compress clutch I cannot seem to find the place to plug it in though. Probably the reason why I could not find it in the first place? can you point me in the right direction? Thanks!
USArmyCombatMedic is offline   Reply With Quote
Old 10-12-2013, 07:12 PM   #6
RandyP
Getting Old; Going Broke
 
RandyP's Avatar
 
Join Date: Apr 2010
Location: Owasso OK
Posts: 2,764
Re: Where does this connector go?

Standing in front of the truck, here are a couple of snap shots to help. It's actually on the front of the compressor, not the back or side.
Attached Images
  
__________________
Why is every used 350 sbc out of a corvette?
There's only two things that excite a man, expensive toys and real expensive toys.
VEGETARIAN: That's an old Indian word meaning "I don't hunt so good."
When the going gets tough, switch to power tools.
RandyP is offline   Reply With Quote
Old 10-13-2013, 04:18 PM   #7
USArmyCombatMedic
Registered User
 
Join Date: Oct 2013
Location: Rushford, MN
Posts: 23
Re: Where does this connector go?

Thanks guys! I found it and plugged it in! Good pics Randy found it right away! Thanks again.
USArmyCombatMedic is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:17 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com