help with headers

[85chevy86]

Looking at a set of headers on craigslist. They are for a second gen Camaro I think the part number is Flowtech 11100. Any body know if these will fit a 86 c-10 with a 305? Jegs and summit don't show them fitting but I now some car headers will fit.

Thanks

[gchemist]

I use Chevell 3/4 length headers on my ZZ4. Headers from '60s to early 80's fit. I bought mine for an early '70s F body car.

[85chevy86]

so being full length they should work?

[gchemist]

Yes, but they stick down further. Mine are nicely tucked right level with the frame. Only the driverside header hangs low enough below the frame to see about half of the connection.

What years are the second Camaros?

[85chevy86]

Did not say the year. May just see how cheap I can get them. If they are not to much I may just try them

thanks again

[85chevy86]

Guy just texted me and said $50 and they have never been fired up. Thank it would be good to try it or just get ones that are made for the truck? Also do you think they would hang do to low and look like crap?

[cadillac_al]

I think they all exit right beside a th350 trans. I think the Impalas and Camaros and trucks will all take the same header.

[f.monroe]

Second gen camaros are 70-81 and several people use them on trucks that have been lowered. They tuck up nicely . There may be a spot on the drivers side where they are close to the frame but they generally fit nice.
Frank

[85chevy86]

Thanks for the reply guys. I am going to thank about it and maybe try to get a hold of the guy this weekend.

[school boy]

not sure on how much difference on the 2cnd and 4rd gens are but heres a set of 3rd gen Camaro long tubes on my 86 c10.

[85chevy86]

well that doesn't look bad. I think I am going to get some measurements and give the guy a call this weekend

[gchemist]

I'll dig up a few photos my headers.

[85chevy86]

Just a incase any one else is wondering they fit and look nice. About like school boy's are.