|
|
|
07-15-2003, 06:30 PM
|
#1 |
|
Registered User
Join Date: May 2002
Location: Dowagiac, MI US
Posts: 579
|
spindal question
I have a 3/4 ton and I want to lower it some and swap it to a 5 lug disc setup. Do I need to change the upper and lower control arms, the tierods, etc. in order to put on a 5 lug disc spindal?
thanks for any help brad 
|
|
|
|
07-15-2003, 07:33 PM
|
#2 |
|
Registered User
Join Date: Feb 2002
Location: Vacaville, CA
Posts: 2,746
|
Someone can correct me if I'm wrong but I believe the 3/4 ton upper and lower ball joints will fit the 71-72 disc spindles, I don't know if the tie rod ends will fit.
P.S. what year truck?
__________________
 70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI |
|
|
|
|
07-15-2003, 08:37 PM
|
#3 |
|
Registered User
Join Date: May 2002
Location: Dowagiac, MI US
Posts: 579
|
its a 69.
|
|
|
|
|
07-15-2003, 10:28 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,403
|
the upper a arms, & the crossmember will work. You need to swap the lower a arms(due to ball joint sizing), then swap all the ball joints to go 1/2 ton(5 lug)+ tierod assys(inners, outers, & sleeves). The center link may or may not work......just watch the taper on the holes when you install the tierods. as a rule, 71 on is a go on the center link. Also, you can use 73 up spindles......just use the corresponding ball joints, & outer tierod ends.( the upper ball joint, & outer tierod ends have a different taper on the 73 up 1/2 tons) Good luck,crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... Last edited by crazy longhorn; 07-15-2003 at 10:32 PM. |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
