gm steering column wire harness cover

[36chevy]

I am using a 80's standard gm steering column in my 58 pu. Does anyone make something to cover the ignition switch and wire harness ? Looks really ugly.

[Tomb23]

The Original 70-80 Column had a Cover ! You do not have it ?

[36chevy]

I have the plastic cover under where it tilts but not sure if there is one under that.

[Tomb23]

Got one in the shop i'll dig out later for ya to see , it's about 7" long and 1" 1/2 wide, little rounded

[_Ogre]

made my own out of fiberglass. incorporated a dash fascia into it to hide wiring and ac vents

[G&R's57GMC]

Hard to see from this angle, The carpet covered steering column or a panel like the one Ogre posted except made from cardboard coved with upholster

[36chevy]

You would think after all these years somebody would have made a fiberglass mold considering most people use the same column?

[oldman3]

I'm not sure but I think Rod Doors, made a column cover in plastic, like their door panels, but I'm not sure if their still in business...Jim

[36chevy]

I just checked their site. They did make a mold for Gm columns. Looks like they are out of Business.

[OrrieG]

I modified a piece of 4" thin wall pvc pipe and upolstered it. I made a piece to cover the exposed part above the dash and below the tilt mech. The details in my thread start here:
http://67-72chevytrucks.com/vboard/s...&postcount=447

[Ainsy]

You can go to a carpet store and get a carpet tube to start with, mock it up to fit and cover with whatever.

[Rude Dude]

Speedway has one

http://www.speedwaymotors.com/Lower-...over,2050.html

[Ainsy]

Carpet tube cost = 0.00

[36chevy]

Speedway one looks pretty good. Has anyone ever seen one installed? Looks like you have to remove the stock gm cover?