|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-21-2003, 03:00 PM
|
#1 |
|
No longer truckless
Join Date: Mar 2002
Location: Campbell, CA
Posts: 299
|
single wall blazer top width?
Does anyone know how wide a single wall top is in the area between the driver & pass door? I want to find out if a single wall top will fit around my cage in the main hoop area.
|
|
|
|
07-21-2003, 07:11 PM
|
#2 |
|
Account Suspended
Join Date: Sep 2000
Posts: 3,991
|
At the bottom of the top at the back door pillar the top is flush with the sheet metal, at the top it tapers up to about 53"
|
|
|
|
|
07-21-2003, 10:16 PM
|
#3 |
|
No longer truckless
Join Date: Mar 2002
Location: Campbell, CA
Posts: 299
|
If that's true then a single wall top is actually more narrow than a doule wall top so that blows my theory out of the water.
Just to be sure I am telling you the right place to measure, I'm looking for a mearurement along the whole length of the window rolled up. My roll cage is ~58" wide. It is 2" OD tube & it sits ~1/2 inch above where the window is if it's rolled up all the way. I'm trying to figure out if a single wall top would fit around the top. I will post a pic later. It's too hot in this house. I'm going to the pool. |
|
|
|
|
07-22-2003, 12:48 AM
|
#4 |
|
No longer truckless
Join Date: Mar 2002
Location: Campbell, CA
Posts: 299
|
Here are the pics. Please tell me the top is wider than 58" at this spot.
  
|
|
|
|
|
07-22-2003, 09:09 AM
|
#5 |
|
Account Suspended
Join Date: Sep 2000
Posts: 3,991
|
I don't think it will fit. I measured at the back door pillar where the latch is and at the highest point and that measurement was 53" so I would think it would only get narrower the closer to the windshield you get.
|
|
|
|
|
07-22-2003, 10:28 AM
|
#6 |
|
No longer truckless
Join Date: Mar 2002
Location: Campbell, CA
Posts: 299
|
That's not good news, but thanks for taking the measurements for me.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
