|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-19-2014, 07:42 PM
|
#1 |
|
Registered User
Join Date: Nov 2013
Location: ATLANTA
Posts: 223
|
Parking Brake intermediate question
My parking brake adjustment system has sat for years and years against a rusty exhaust pipe as a result the adjustment screw has rusted completely flat on one side and the adjustment nut is also flat on the same side. Needless to say I cant spin the nut around the adjustment screw to adjust the parking brake.
On LMC they sell an intermediate cable does anyone know if this comes with the screw attached to one end allowing it to be adjusted? |
|
|
|
04-19-2014, 07:55 PM
|
#2 |
|
Registered User
Join Date: Jul 2012
Location: Jonestown, TX
Posts: 471
|
Re: Parking Brake intermediate question
I think you'd need the primary cable, which has the threaded end on it with 2 hex nuts to adjust with. I ordered the intermediate cable from LMC to replace my existing cable, and it shipped as the cable only
|
|
|
|
|
04-19-2014, 08:04 PM
|
#3 |
|
Registered User
 
Join Date: Jun 2012
Location: Fitchburg,Mass
Posts: 737
|
Re: Parking Brake intermediate question
You need the primary cable.....primary cable goes from foot pedal to intermediate cable, then too each parking brake cable...
__________________
62 Willys 4wd Pickup : 72 C-10 swb 504 stroker 09 Taco 3" lift 33" tires: 90 K-5 blazer (plow truck): RIP Ross Little brother
|
|
|
|
|
04-19-2014, 09:51 PM
|
#4 |
|
Registered User
Join Date: Nov 2013
Location: ATLANTA
Posts: 223
|
Re: Parking Brake intermediate question
Perfect, thank you.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
