![]() |
![]() |
#1 |
Registered User
Join Date: Oct 2010
Location: Riverton Wyoming
Posts: 93
|
70 c10 GMC axle ID
can anyone help me ID my 12 bolt? the axle is too far rusted to be able to see, without sand blasting, which i dont have access to at this moment.
Its a 70 GMC SWB step side, and i was wondering what possible axles it has in it (spline count) so i can prepare.. im trying to get a new set of axles and a locker for it. its a 6 lug, 2WD. Please and thanks guys youd be doin me a huge favor.
__________________
"Its better to burn out than it is to rust!" '70 GMC C10 2wd. 2.02 aluminum heads. TH400 trans. 450WHP '04 Nissan 350z DD, Twin Turbo, 600whp, drag beast! |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Oct 2010
Location: Riverton Wyoming
Posts: 93
|
Re: 70 c10 GMC axle ID
this is the truck.
__________________
"Its better to burn out than it is to rust!" '70 GMC C10 2wd. 2.02 aluminum heads. TH400 trans. 450WHP '04 Nissan 350z DD, Twin Turbo, 600whp, drag beast! |
![]() |
![]() |
![]() |
#3 |
Special Order
![]() ![]() Join Date: Nov 2004
Location: Mt Airy, MD
Posts: 85,861
|
Re: 70 c10 GMC axle ID
Get ready to install before ordering by draining the gear oil and removing the cover. Once that's off you can count teeth and/or read the numbers on the ring gear. Put the cover back on and it will be fine till you tear into it.
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~ |
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Oct 2010
Location: Riverton Wyoming
Posts: 93
|
Re: 70 c10 GMC axle ID
I was avoiding pulling the cover, I'm military so im not near my truck at all times. It's about 2600 miles from me, was just wondering what the spline counts for the c10s were, 33,32,31?
__________________
"Its better to burn out than it is to rust!" '70 GMC C10 2wd. 2.02 aluminum heads. TH400 trans. 450WHP '04 Nissan 350z DD, Twin Turbo, 600whp, drag beast! |
![]() |
![]() |
![]() |
Bookmarks |
|
|