GM Dana 60 drw to Dodge srw hub identify help !

[72MARIO]

I have a pair of what I think are 80's dodge srw front hubs I am looking at converting a GM drw Dana 60 front. I am hoping someone could help identify these hubs. They are stamped BUDD 102764. I would like to use them to convert the dually front to a single wheel Axel. I think it should work all I have is these hubs and rotors. I got them at a estate sale they were in original boxes just really wet.

[Jsfucttruck]

A brief Google search lead me to quad4x4. They recognized that casting number as a Dodge Dana 60 internal splined hub. Available on 89' and later models.

Look up the bearings and seals for a Chevy 60 and compare the part #'s to the dodge listings. If they are the same, try it.

Hope it helps, good luck.

Let us know what you find.

[b454rat]

They are the same but the rotor is different, again it will work. I'm pretty sure Dodge and GM calipers/pads are the same. Dodge rotor is thinner than the GM rotor....

[Maxxd07]

Also the D60 in my 89 dodge has only 1/2 studs in it. I believe the Chevys have 9/16 studs.

[BLAZERMAN]

I ran the early 80s Dodge external drive hubs on my GM Dana 60, I used GM callers, rotors and bearings. The Dodge hubs did use 1/2" wheel studs but the GM 9/16" studs fit the Dodge hubs.

[72MARIO]

So I just need to find the manual locking hubs for a dodge that fit this hub ? The everything else is a bolt in ?

[b454rat]

If the Dodge uses the external hubs yes. If not, they GM, Ford and newer Dodge (89-93 roughly) uses the same lock outs.

[68post]

Did you get this swap done ? I need to change-over my dually to srw front and rear also.
Looking for more info.

[72MARIO]

No I haven't yet. Going to be a while honestly most likely next winter. But from everyone I talked to it sounds like it should work.

[68post]

OK , thanks. I'm digg'n for info - if I have anything to lend I'll be back to spill the beans !