IA GM serpentine bracket kit-detailed!

[gmachinz]

I have (2) of these available-all GM stuff, sandblasted, etch primed, painted and cleared. I am including my 140A alternator adapter bracket also! PM with questions-all mounting hardware has been wirebrush cleaned and lightly oiled for a new look! I also include a guided water pump pulley for a smoother running belt alignment. I am including this as a basic kit which allows you to decide on where to purchase your own accessories. The 140A alternator I use for these is a 1994-97 Impala SS. PM me for more questions/conderns-I can supply a HD 4 ga charging system upgrade if you would like as well! Price as seen in pics is $275 shipped to the lower 48.

[slimneverdies]

Any of these for BBC?

[gmachinz]

Sorry but no-I dont have a kit for the BBC's. I'm out of stock on my optional GM 140A brackets for a SBC, so I have these kits for use with my 140A bracket adapter instead.

[gmachinz]

This is the 140A GM kit that I had a few sets of-might have a few more coming but not sure when. This kit was $279.

[gmachinz]

Just an update-I have these CS upgrade harnesses available with or without GM serpentine bracket kits as well now-included is a replacement 10ga output charge lead which routes to your firewall junction along with the remote voltage sense lead and the "excite" circuit is a full replacement from your firewall bulkhead out and is pre-soldered with a 300-ohm resistor and flyback diode inline to protect from ignition run-on and maintain a steady charge state. Harness is wrapped with loom tape, covered with heat resistant Delphi automotive loom and I include plasti-dipped clamps so you can neatly secure the charging system upgrade harness to a couple intake manifold bolts!

Again, this is a GM style CS alternator upgrade harness and is available separate as shown or can be incorporated into a complete serpentine specific GM engine harness for use on your truck!

Price is 69.99 for the harness as shown.