|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-25-2003, 05:02 PM
|
#1 |
|
Registered User
Join Date: Aug 2003
Location: Alabama
Posts: 3
|
Looking for the needle in the hay stack!
I just purchased a 1968 Chevy C60 2-ton truck. I'm searching for right inner fender and outer fender. The problem I've found in all the salvage yards is the same problem RUST! Is there any company remanufacturing these fenders? They are not like the 1/2 or 1 ton. The fenders flair out about 3" at wheel opening, also they have a extenison that attaches to step board. I don't mind a small amount of rust, but most I've seen is beyond repair due to the battery.
|
|
|
|
08-25-2003, 05:14 PM
|
#2 |
|
Post Whore
 
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,684
|
Hopefully someone will have some info for you, I haven't seen any remanufactured products for the big trucks.
Welcome to our board and would enjoy seeing some pics of your 2 ton truck!
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
