|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-27-2015, 09:26 AM
|
#1 |
|
Senior Member
 
Join Date: Feb 2001
Location: Killen, Alabama USA
Posts: 3,574
|
How to mount 67-68 bumper guards?
I found a set of used guards at a swap meet and I'm trying to figure out how to install them. There's a clip on the top side the slides over the top edge of the bumper. There is another threaded hole about midway down the inside of the guard. However it does not line up with the factory holes in the bumper. Do I have to drill a hole in my bumper or am I missing a bracket?
__________________
72 Cheyenne Super swb. Factory 402/400,tach,posi,AM/FM, A/C. Adding cruise, 8-track 72 Cheyenne Super swb. 350/350 A/C, bucket seats 72 Cheyenne swb. Factory 402/400, tilt, posi, A/C 72 Cheyenne Super K-10. 350/4 spd., posi. 72 Suburban 350/350 tilt, tach, AM/FM, A/C, luggage rack 72 GMC Sierra lwb. 350/350, A/C. medium green/olive interior |
|
|
|
03-27-2015, 10:41 AM
|
#2 |
|
Registered User
Join Date: Jun 2011
Location: Osceola, Ia
Posts: 2,017
|
Re: How to mount 67-68 bumper guards?
I had to drill a hole
 . I dont think there is any other way on the 67/68. Mine came off an original truck although dealer installed i think.
__________________
Shawn 68 chevy K/20 05 chevy 3/4 4x4 71 short step-sold 71 chevy Beauville van My build. http://67-72chevytrucks.com/vboard/s...d.php?t=633039 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
