Source for rear engine mounts for my '69

[allflatblack]

Hey guys, new to the board. I have been slowly putting together a ratty '69 C10 long bed for the last few months. It has a great body with an '83 350 mounted to a Muncie M21. It looks like the truck was built by a guy, the transmission fell apart and it was put away for a few years. I just rebuilt the transmission and replaced the clutch and noticed that only the top cushions of the bellhousing mounts for the rear engine mounts were there. the truck had been operating with only the two front mounts actually attached to the frame.
I ordered the necessary rubber parts from LMC, but I feel like they are missing some type of inner steel sleeves, as well as any washers and bolts, which run through the lower and upper rubbers and screw into the bell housing.
Any thoughts on a good source for these parts or a drawing?
NAPA and online are very vague.

Thanks.

John

[michael bustamante]

i have those if you need them. pm me