|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-01-2003, 09:05 PM
|
#1 |
|
Registered User
Join Date: May 2000
Location: Torrance, Calif.
Posts: 36
|
Electric Fuel Tank Selector
I have to replace the fuel tank selector valve and I am going to do filters and hoses at the same time. Is this a straight forward job or is there something to worry about. Is there any problems with valves. I was looking at a Pollak Electric Motor Driven.
Any help thanks Pops
__________________
67 long bed step side/future fuel injected 502 73 Cheyenne super20/ fuel injected 454 |
|
|
|
10-01-2003, 11:15 PM
|
#2 |
|
Stylin
Join Date: Sep 2001
Location: Tuttle, OK
Posts: 620
|
if the connections are the same on the valves then its straight foreward, everything is cramped up and i would go ahead and replace the hose's running off the tanks if i we're to do this again, im pretty sure they'll be some rubbing on them and thevy probally wore a little thin. taking the bed off will make this a no brainer, i would like to go stainless braided lines if i could but dont have the money or time....
__________________
Ive been traveling for some time, with my fishin pole and my bottle of shyne. Most Girls like finished products and just dont understand what a good addiction does for you http://www.paulwall.us/ |
|
|
|
|
10-02-2003, 05:09 PM
|
#3 |
|
I'm back with 2nd truck!
Join Date: Feb 2002
Location: Texas
Posts: 3,774
|
He's right in that taking the bed off will help on the replacing of lines. I'm not sure on the valve you want to use but on the GM replacement it was a direct swap over.
__________________
1979 Chevrolet Bonanza Big10 "Tootsie Roll" 1985 Chevrolet Silverado (wife's) Member of the Southern Bowties Club "Don't underestimate how sexy a fat man who drinks to excess can be." Homer Simpson |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
