60-63 Tips on re-installing doors - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**AngryPirate** · 03-25-2019, 03:57 PM

I've had the doors off to do work on the cab and now it's time to put them back on.

That work on the cab was painting as well, so the marks where everything used to be are gone.

I got the drivers door on, but it gets hung up on the latch and takes a good tug to get open.

I'd like to fine tune that door and possibly do something different/better to put the passenger side on.

I searched this forum, but my query must've been to generic.

Thanks!

**nsb29** · 03-25-2019, 06:39 PM

No magic bullet a lot of adjusting

**AngryPirate** · 03-26-2019, 10:14 AM

Quote:

Originally Posted by nsb29

No magic bullet a lot of adjusting

Well, at least I'm not doing it the hard way, just the only way.

Thanks for the response!

03-25-2019, 03:57 PM	#1
AngryPirate Senior Member Join Date: Jan 2012 Location: Austin, TX Posts: 564	60-63 Tips on re-installing doors I've had the doors off to do work on the cab and now it's time to put them back on. That work on the cab was painting as well, so the marks where everything used to be are gone. I got the drivers door on, but it gets hung up on the latch and takes a good tug to get open. I'd like to fine tune that door and possibly do something different/better to put the passenger side on. I searched this forum, but my query must've been to generic. Thanks!

03-25-2019, 06:39 PM	#2
nsb29 Senior Member Join Date: Feb 2014 Location: new smyrna beach fl / 29 palms cal Posts: 1,727	Re: 60-63 Tips on re-installing doors No magic bullet a lot of adjusting __________________ Hand made A/C vent manifolds for 64-66 trucks adapts any aftermarket A/C to OEM vent



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.