|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-08-2019, 04:16 PM
|
#1 |
|
Senior Member
 
Join Date: Jan 2007
Location: Turlock, CA
Posts: 8,739
|
Serpentine pulley tool question
OK so this has me stumped. How do I torque down the 15/16” nut while holding the shaft in place (hex head screw)? The pulley is fairly deep so I can’t get a regular wrench in there.
__________________
Please help my sister in law with her battle with cancer https://gofund.me/902f6fce Project "C10 Fever" (68 factory black 396 swb) Project "Little Sister" (70 c10 blue original paint refresh) Project "Blue Bomb" (70 c30 blue original paint refresh) SOLD Project "Vitamin C" (71 c10 orange original paint refresh) SOLD |
|
|
|
09-08-2019, 04:34 PM
|
#2 |
|
Senior Member
Join Date: Jan 2001
Location: Orem, Utah
Posts: 7,954
|
Re: Serpentine pulley tool question
Impact wrench, maybe? Hold the pulley and let the impact do the job. How critical is the torque on that nut - is it possible to over-torque it?
__________________
I have sworn upon the altar of God, eternal hostility against every form of tyranny over the mind of man. - Thomas Jefferson |
|
|
|
|
09-08-2019, 05:35 PM
|
#3 |
|
Senior Member
Join Date: Jan 2007
Location: Turlock, CA
Posts: 8,739
|
Re: Serpentine pulley tool question
Thanks for the quick replies. I used an impact gun, I think that should work. There’s a lock nut underneath and it just has to hold up to the alternator internal spinning resistance.
__________________
Please help my sister in law with her battle with cancer https://gofund.me/902f6fce Project "C10 Fever" (68 factory black 396 swb) Project "Little Sister" (70 c10 blue original paint refresh) Project "Blue Bomb" (70 c30 blue original paint refresh) SOLD Project "Vitamin C" (71 c10 orange original paint refresh) SOLD |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
