|
12-04-2003, 11:43 PM
|
#1 |
|
student wrench turner
Join Date: Jan 2003
Location: wrightstown, wisconsin
Posts: 192
|
Ball Joints
I just replaced the ball joints in my truck and the repair manual says to torque the top ones to 50 ft. pounds but it doesn't say anything about the bottoms and i want to know if i should just torque them to 50 or am i missing something in the book?
__________________
1969 Chevy C-10 with 250 L6 2002 GMC Sierra 2500 HD Duramax with banks six gun |
|
|
|
12-04-2003, 11:48 PM
|
#2 |
|
Cause the Chicks DIG IT!!
Join Date: Nov 2003
Location: Beaufort SC
Posts: 509
|
I think you'd be safe at 50
|
|
|
|
|
12-05-2003, 12:12 AM
|
#3 |
|
Senior Member
Join Date: Apr 2000
Location: Delta,Pa
Posts: 14,950
|
usually run them on till there tight and then turn the nut until you can put the cotter pin in
__________________
Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
