PA WTB. 4 speed flywheel cover

[shoveldug]

Need a flywheel cover

[1rippen6]

I have one, I'll get you some pictures tomorrow.

[Ironhorse]

Just to be sure, you are referring to the metal cover for the standard shift trans correct? Think I may have on in the parts stash. Will check tomorrow and get back to you.

[shoveldug]

Originally Posted by 1rippen6

I have one, I'll get you some pictures tomorrow.

Thanks
Posted via Mobile Device

[Ironhorse]

Found the 4 speed flywheel cover along with the starter shield that is also used when mounted. Digital camera is charging, can post up pics later if interested in the two pieces. Let me know if have an interest, thanks.

[shoveldug]

Originally Posted by Ironhorse

Found the 4 speed flywheel cover along with the starter shield that is also used when mounted. Digital camera is charging, can post up pics later if interested in the two pieces. Let me know if have an interest, thanks.

Yes. Interested!
Posted via Mobile Device

[Ironhorse]

Pics of the metal flywheel cover I have and the starter shield. Both need a good cleaning, normal light grime and dirt. Flywheel cover is in great shape, no torn mount bolt holes or rust. The starter shield does have a small split at the lower corner but really don't see that being a problem. Perhaps could be welded with a Tig or Mig set-up? $40 plus ship for the two pieces. I don't have Paypal, money order payment if interested.

Flywheel cover pics first

[Ironhorse]

Pics of starter shield. Pencil points to the small split.

[1rippen6]

Did you get what you need or are you still looking.

[shoveldug]

Originally Posted by 1rippen6

Did you get what you need or are you still looking.

Sorry I have not been on here in a while. I did not find what I was looking for. I also think I asked or was looking for the wrong cover. I actually have a four speed transmission out of a 1976 K20 in a 1967 K20. I believe they must be different. The transmission I have has a aluminum bell housing attached to it. This is a frankinstien truck. I will try to get some pictures of what I have. My knowledge of these parts is limited.

[shoveldug]

Originally Posted by Ironhorse

Pics of the metal flywheel cover I have and the starter shield. Both need a good cleaning, normal light grime and dirt. Flywheel cover is in great shape, no torn mount bolt holes or rust. The starter shield does have a small split at the lower corner but really don't see that being a problem. Perhaps could be welded with a Tig or Mig set-up? $40 plus ship for the two pieces. I don't have Paypal, money order payment if interested.

Flywheel cover pics first

Sorry I did not reply sooner. I thank you very much for the time you put in looking for the parts I asked for and taking pictures Please see above post.