|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-21-2020, 09:46 AM
|
#1 |
|
Registered User
Join Date: Apr 2013
Location: Miami FL
Posts: 28
|
A/C compressor rattle.
My 82 c10 still has the original r12 compressor and it works, however it's been making a rattle noise that sounds like the bearings are going out. Are these bearings on the clutch or part of the compressor? Any fixes other than replacing the compressor?
Where can I buy a replacement compressor that's not used? Thanks
__________________
82 c10, 383 stroker, small cam, edelbrock performer, edelbrock 4 barrel 650cfm, accel super coil, headers, bell tech suspension, low and shaved, door poppers, flat red oxide paint, flowmaster 40 dumps. |
|
|
|
06-21-2020, 04:38 PM
|
#2 |
|
Registered User
Join Date: Aug 2012
Location: Oklahoma City, OK
Posts: 2,620
|
Re: A/C compressor rattle.
The older long cylindrical compressors can have both the front bearings and clutch replaced. IIRC - without breaking the refrigerant seal. Not sure about the later pancake compressors.
|
|
|
|
|
06-21-2020, 06:35 PM
|
#3 |
|
Registered User
Join Date: Nov 2008
Location: Gwinnett GA
Posts: 1,803
|
Re: A/C compressor rattle.
I just ordered a new R4 compressor for my 82. $235 on Rockauto. New by four seasons.
__________________
1982 K10 SWB 1987 V20 - Sold - Doh! |
|
|
|
|
06-22-2020, 09:14 PM
|
#4 |
|
Registered User
Join Date: Apr 2013
Location: Miami FL
Posts: 28
|
Re: A/C compressor rattle.
Sweet, that's not bad. So I'm guessing I'll need the receiver dryer also and some r12 compatible refrigerant?
I'll do some more research to see if I can swap the bearing first.
__________________
82 c10, 383 stroker, small cam, edelbrock performer, edelbrock 4 barrel 650cfm, accel super coil, headers, bell tech suspension, low and shaved, door poppers, flat red oxide paint, flowmaster 40 dumps. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
