NC WTB 67 C10 front fender patch panel

[Rustbuster]

I need a patch panel for the passenger side front fender on my 67 C10 . The front upper corner above the headlight and along the front edge beside the headlight was crushed and had about an inch of bondo in it. I can use a section about 8 inches from the front edge and about 12 inches down from the top edge next to the hood. Or if somebody has a 67 or 68 fender that is damaged on the rear but has a good front section, I could use the front 22 inches . My inner brace is straight and solid.

[Clatterville trolley]

Originally Posted by Rustbuster

I need a patch panel for the passenger side front fender on my 67 C10 . The front upper corner above the headlight and along the front edge beside the headlight was crushed and had about an inch of bondo in it. I can use a section about 8 inches from the front edge and about 12 inches down from the top edge next to the hood. Or if somebody has a 67 or 68 fender that is damaged on the rear but has a good front section, I could use the front 22 inches . My inner brace is straight and solid.

I have several 67 fenders and can look to see if there is one that would fill the bill for you. Will check tomorrow and let you know. Thanks - Jay

[Rustbuster]

Thanks Jay.

[Rustbuster]

I found one locally. Thanks anyway Jay.

[Clatterville trolley]

Originally Posted by Rustbuster

I found one locally. Thanks anyway Jay.

Thanks for letting me know and I am glad you found one. I looked at the ones I had and they were border line, but still to good to cut up I think. Jay