Captain Fab Power Steering conversion column alignment question (with pictures)

[Bushman66]

Hi all,

I got my power steering box into my 66 C10 using Captain Fab's bracket. If you look at the pics, the (stock) column is perfectly aligned with the input shaft on the box, but the column shaft is offset about 1/2" toward the passenger side. I'm afraid this is going to put stress on the rag joint when I hook it all together.

Note: (The flange is not set in final position on the shaft yet).

Any suggestions? Anyone run into this before? Is there an adjustment I can make up under the dash to shift it closer in line with the box?

Thanks!