Fuel Routing Question

[ladybugblazer]

My 79 Blazer currently has all rubber fuel line and I've recently started looking into replacing it all because of potential fire hazard etc. A lot of the existing steel line is there on the inside of the frame rail, but the PO just left it and capped it off/cut off some pieces. The existing steel line here that is capped off includes: fuel return, smog, and fuel line. The smog seems to be deleted and there is no charcoal canister on the truck.

The PO also installed an electric fuel pump on the back right of the frame rail facing outside the truck near the fuel tank. He basically then routed all the rubber fuel line on the outside of this frame rail (on the other side on the inner frame rail the existing steel line is there) and then once it got close towards the engine bay just brought it up and connected it to the carb (no mechanical fuel pump b/c electrical). The fuel filter is currently in the middle of the line running down the frame too. The first fuel filter is right before the electric fuel pump and these seem to be the only two fuel filters on the truck.

I want to basically get rid of all the rubber line on the truck and replace it with PTFE 6 AN Braided hose. I've been thinking of running it down the same path as well and was wondering if anybody can see any issues with this. I would rather not remove the existing line right now because there's a lot of things clamped together and I don't wanna mess with including: existing steel lines, active rear brake lines, and wires. I plan on installing insulated fuel line clamps as well all the way down the frame. I also plan on installing a fuel pressure regulator as well and it would be sitting in the back of the engine bay towards the fire wall before the line connects to the current Edelbrock Carburator with an AN fitting. I was just wondering if anybody sees any big issues with doing this or has any past experience. Thanks